Using The Multitest Med. Int - Dräger Aerotest HP Instructions For Use Manual

Using the MultiTest med. Int.

Insert tube
The following media can be tested:
O , Air, CO , N O and N .
2 2 2 2
Two signs can be found on the measuring device:
Sign 1
O Air
2
Sign 1 specifies the media that can be tested. A colour can be found
under the testable media.
Sign 2
Oil CO SO
2 2
Sign 2 specifies the substances that can be detected. A sequence of
colours is located above each substance.
28
CO N O N
2 2 2
H S NO CO H O
2 x 2
Example:
Measuring the O supply
2
Sign 1
– The colour white is shown
below the O symbol.
2
● For test times, see the table
(see "Table of measurement
recommendations/limit
values for MultiTest" on
page 29).
Sign 2
● Fit the measuring device with the white test tube (here CO
and H O).
2
Oil CO SO
2 2
● Break off the Dräger tubes as described, see "Prepare Dräger
tube" on page 25 and insert them in the Dräger tube holder in the
direction shown by the arrow.
● Pull on the bottom end of the Dräger tube container until the
Dräger tube can be completely inserted in the Dräger tube holder.
O Air
2
H S NO CO H O
2 x 2
, CO
2