Watson-Marlow 520DUN User Manual page 22

Watson-Marlow 520DuN IP66/NEMA 4X User Manual
First-time start-up defaults
Language Not set
Speed Maximum
Direction Clockwise
Pumphead 520R
Tube size 9.6mm
from head and tube
Calibration
table
Backlight On
Keypad lock Off
Auto-restart Off
Scaling Off
Pump status Stopped
Beeper On
Manual screen rpm
Security code Not set
Note: The settings shown above for Run, Clockwise rotation and Auto are those in
force on initial start-up for the functions available on Output 1, Output 2 and Output
3 respectively. For example, a high signal on Output 2 indicates clockwise rotation.
These can be exchanged later according to user requirements.
Note: High is equivalent to the common and normally open contacts of the relay on
the adapter board being closed.
The pump is now ready to operate according to the defaults listed above.
All operating parameters may be changed by means of key-presses. See 14 Manual
operation.
Analogue input
User trim
Remote stop
Pump number
Baud rate
Stop bits
Xon/Xoff
Scrolling increment
Output 1
Output 2
Output 3
Output 4
Run *
Clockwise rotation †
Auto ‡
4-20mA
None
Open=run
1
9600
2
Off
0.1rpm
Run/Stop *
Direction †
Auto/Man ‡
General alarm
= high
= high
= high
22