Page 2
NOTES Model Number: __________________________________________________________________ Serial Number: ___________________________________________________________________ Date of Purchase: ________________________________________________________________ Retain this manual as a permanent record of your purchase.
Page 3
Check the carton for shipping damage. Carefully unpack and Introduction ...........3 inspect your new Powr-Flite equipment for shipping damage. Each unit is tested and thoroughly inspected prior to shipping. Safety Instructions ........4 If damage is discovered, immediately notify the transportation company that delivered your machine and request an Grounding Instructions .........5...
IMPORTANT SAFETY PRECAUTIONS To reduce the risk of fire, electric shock, or injury WARNING!: WARNING WARNING To avoid electric To avoid fire, DO NOT shock, DO NOT use with a flammable expose to rain. or combustible liquid Store Indoors. to clean floor. When operating this machine, the following precautions should always be followed: DO NOT leave unit when plugged in.
Page 5
Cutting off the ground wire or using a cord that is not equipped with a ground plug will void the warranty on the unit. Powr-Flite will accept NO liability associated with the unit. Improper connection of the equipment-grounding conductor can result in a risk of WARNING! electric shock.
GENERAL DIAGRAM Hard Surface Tool Recovery Tank Wand Holder Clip Vacuum Inlet Solution Line P.S.I. Gauge Pressure Control Wand Holder Solution and Vacuum Hose...
Page 7
GENERAL DIAGRAM Manual Dump Hose Loading Wheels Solution Line Inlet Cord Hook Autodump Outlet Vacuum Switch Dual Circuit Indicator Autodump Circuit Pump Switch Breaker Autodump Switch Transport Wheels...
GENERAL INSTRUCTIONS MACHINE SET UP This machine is designed as a direct feed solution system with a recovery tank with the option to auto dump. To set up your machine: 1. Make sure hoses are in good condition and spray nozzle on wand is tight. 2.
Page 9
GENERAL INSTRUCTIONS OPTIONAL: DRYING YOUR FLOOR WITH SQUEEGEE TOOL (Not Included) 1. Verify the vacuum hose is securely connected to the machine and wand. Connect the squeegee tool to the wand. 2. Turn on the vacuum switch to vacuum excess water. DRAINING RECOVERY TANK 1.
Page 10
PRODUCT SPECIFICATIONS MODEL PFX1200RT Power Cord 25 ft. 12 gauge, 3-wire (2) Water Supply Hose 25 ft (2) Recovery Tank Capacity 15 gallons Vacumm Intake Hose 30 ft Water Lift 135 in Front Wheel Size 4 in Rear Wheel Size 12 in Tank Construction Polyethylene...
TROUBLESHOOTING PROBLEM CAUSE SOLUTION Poor pick up. Inlet basket filter is clogged. Clean filter. Loose drain hose connection. Tighten drain hose. Loose recovery tank lid. Position the lid correctly. Damaged hose. Replace hose. Suction relief is open on wand. Adjust or close suction relief on wand. Vacuum motor does not operate Unplugged cord.
Page 15
MODEL PFX1200RT PARTS PFX1200RT recovery tank assembly PART NO. DESCRIPTION PART NO. DESCRIPTION NEEDED NEEDED 70343A SWITCH FLOAT 2 POLE 7BH004 SCREW 10-32 X 3/8 PHIL PAN SS 71328A SHIELD FLOAT SWITCH 7BS003 SCREW 1/4-20 X 1/2 PHIL PAN SS 71644A SCREW #10 X1 PHIL PAN SS 7DA001...
Page 16
A Tacony Company 3101 Wichita Court • Ft. Worth, TX 76140-1755 1-800-880-2913 • Fax: 1-817-551-0719 • www.Powr-Flite.com PFX1200RT-MAN 12/2015...
Need help?
Do you have a question about the PF1200RT and is the answer not in the manual?
Questions and answers