Watlow Electric Gateway & DeviceNet Configuration

Configuring the RUI/Gateway on DeviceNet
1. Prior to making the physical connections on the network setup the gateway DeviceNet
communications parameters per your network requirements, i.e., baud rate and node
address. If your not sure how to do this go to
®
ZONE PM Communications Manual and follow the procedure defined in the DeviceNet
chapter.
2. Once the gateway communications parameters for DeviceNet
network requirements connect the gateway into the network and do the following:
a. Run RSLinx software and configure the driver of choice
b. Run RSNetWorx software.
3. As shown below (within RSNetWorx software), click on the online command from the tools
toolbar and then select the appropriate communications path to browse the DeviceNet
network. Set up in previous step using RSLinx software.
4. After successfully browsing the network all nodes on the network will appear in the graphical
Watlow
1241 Bundy Blvd
Winona, MN 55987
Telephone: 507-494-5656
© 2007 Watlow Electric Mfg Co
RUI/Gateway & DeviceNet
Configuration & Ladder Logic Example
Using an Allen-Bradley CompactLogix PLC
TM
Using RSNetWorx
http://www.watlow.com
TM
1
TM
and download the EZ-
are set according to your
TM
TM
TM
4/08