Advertisement
Available languages
Available languages
BALANCER LAYOUT
Charger Interface
(allows charger to
monitor individual
cell voltages)
10 A Fuse
Charger /
Discharger
Connection
CONNECTING TO A CHARGER
RAYTRONIC charger
Interface Cable
The interface port is:
- on the left side of
RAYTRONIC C10
- on the right side of
RAYTRONIC C30
1. Start with the charger turned off.
2. The „Slave-Master" switch of the balancer switc to the „Master" position.
3. Connect the black connector „Charger" to the (-) output socket of your charger and the red „Charger"
connector to the (+) output socket of your charger.
4. If using a compatible RAYtronic charger (C10, C30), connect the interface cable between the charger
and the balancer. This will enable the charger to record the individual cell voltages.
5. Connect the positive and negative positive battery connections to the balancer („BATT+" and „BATT-").
6. Using the adapter coresponding to you battery pack, connect the balancing connector of the pack to the
„Balancing Port" of the balancer.
7. Ensure that the LED is lit for the correct battery type. If the wrong battery is shown, hold the Mode
button down for 2 seconds until the battery type changes.
Note: The battery type can only be changed within 10 seconds of connecting the battery to the balancing
port.
Mode Button
Connected/Stand Alone
Li-Po/Li-Fe
Charger
OUTPUT
Switch to Master
2
Instruction manual
Slave/Master
Cell Monitoring
(when networked with
another balancer)
Balance
Adapter
Li-poly/Li-Fe pack
2-6 cells
Battery (+)
Voltage sensor
(Balancing port
connection)
Battery (-)
Network Connection
(used to connect to another
balancer)
LEDs
Advertisement
