Technical Data - Davin DV-11T II Manual

1.0 GENERAL
The DV-11T II is a thermostatically controlled
ventilation control system for an EXHAUSTER
or BLOWER, with minimum and maximum
regulation for both engines.

1.1 TECHNICAL DATA

Dimensions
Required voltage
Max. Output
Isolation level
1.2 REQUIRED (ACTIVE) VOLTAGE DV-11T II
To connect the DV-11T II you will preferably need
a 'clean' group of at least 16 Amp.
A 'clean' group means that this group will only
be used by the DV-11T II.
• The DV-11T II needs to be connected directly
to, and near the 'clean' group.
• Install, if needed, a grounded outlet onto your
'clean' group.
• If you do not have a(n) (extra) 'clean' group we
advise you to have a 'clean' group installed by
a certified installer.
1.3 THE INSTALLATION OF THE DV-11T II
The DV-11T II should now be mounted.
At the bottom of the DV-11T II are 2 mounting
brackets; these should be pushed out before you
can use them. The DV-11T II can now easily be
placed on a (flat) surface.
1.4 CONNECTING THE DV-11T II TO A 'CLEAN'
GROUP
• In step 1.2 you have already mounted a
DV-11T II Binnenwerk PMS.indd 5
Manual DV-11T II
• Turn the 'clean' group 'OFF'.
• Insert the plug of the DV-11T II into the outlet
1.5 CONNECTING THE ENGINE (EXHAUSTER)
In steps 1.2 to 1.4;
: 110 x 210 x 70mm.
• A 'clean' group is connected (or we have had it
: 230 Vac / 50Hz.
: 2 x 1350 watt.
• The DV-11T II has been mounted onto a flat
: 2 x 6 Ampère.
: IP-44
• The DV-11T II has been connected to a 'clean'
Now the engine (of the exhauster) has to be
connected to the DV-11T II.
• Insert the plug of the exhauster into the
• Turn the 'clean' group back 'ON'
• If everything is properly connected, the engine
1.6 ADJUSTING THE DV-11T II
Everything is now connected. Now the DV-11T II
can be adjusted for use.
The 2 power outlets;
On the LEFT side of the DV-11T II there is an
outlet for the BLOWER.
On the RIGHT side of the DV-11T II there is an
outlet for the Exhauster.
On top of the DV-11T II there are five black
buttons.
• Button 1 = Thermostat
grounded outlet onto your 'clean' group.
of the 'clean' group.
TO THE DV-11T II
connected by a certified installer.)
surface.
group.
mounting socket (the socket) on the side of
the DV-11T II.
of the exhauster will start.
Set this to the desired temperature.
7
13-6-2012 0:32:41