Troubleshooting - InVento 500006 Instruction Manual

Once you have gained experience and confidence in hovering the quadcopter,
you can attempt more advanced maneuvers (loopings, flips and rolls).
CAUTION: Always fly the quadcopter with your back to the sun to prevent loss of control.

Troubleshooting

Problem Problem cause
Blue LEDs on the Controller too near to quadcopter
quadcopter flash during binding process.
continuously and
quadcopter will
not respond to
transmitter.
Controller does not Controller is not switched on.
work.
Batteries are not properly installed.
Batteries are empty.
Quadcopter does No electric power.
not work.
Controller does not receive a signal.
Batteries in the helicopter and/or
controller are empty.
Motor does not work. No connection between model and
motor.
Motor is defective.
Quadcopter is Strong winds or airflows.
uncontrollable.
Quadcopter does not Unsufficient power.
climb.
Flight batteries are empty.
Landing of the Trottle stick was pulled backwards
quadcopter is too too fast.
hard.
Problem solution
Power off the controller. Move the controller
further away from the quadcopter.
Disconnect and reconnect the flight battery to
the quadcopter. Follow the binding instructions.
Switch on controller.
Remove and reinstall the batteries.
Change batteries.
Check connection between quadcopter and
flight battery.
Check channel/frequency (quadcopter and
transmitter need to be on the same frequency).
Charge the flight batteries or change the
controller batteries.
Check cables and re-solder if necessary.
Change motor.
Do not fly in strong winds or airflows.
Push the throttle stick forwards.
Charge the flight batteries.
Pull the throttle stick back gently for a soft
landing.
19