Battery Change - Pierenkemper Zapper K100 Operating Instructions Manual

attention! the device does not turn off automatically after the end
of the program. as long as the device will not be turned of, an acou-
stic signal will be given.
Electrode Control
the zapper K100 is equipped with an automatic electrode control.
if the electrodes are not connected properly or do not have enough
contact to the patients skin, an acoustic warning signal will be
given.
in this case, please check if the electrodes are connected and placed
properly. if the warning signal still occurs, put a little bit of water
on the skin or tissue underneath the electrode.

Battery Change

TO REPLACE THE BATTERY, TURN OFF THE DEVICE!
if the red battery light (9) flashes, the battery needs to be changed.
slide off the cover of the battery compartment on the back of the
device and disconnect the battery.
check polarity of the battery when connecting the new 9 Volt com-
pound battery (f. e. type 6Lr61) to ensure it is correctly attached.
if the device is not used for a prolonged period, remove the battery.
where rechargeable batteries are used, please follow the instruc-
tions of the charging unit.
dispose of old batteries properly.
15