Ghs Blower; Ghs Exhaust Screen - Walker MT, MTL, MTEFI, MTLEFI Owner's Manual

Maintenance Instructions
NOTE: While some degree of material buildup
in the mower deck housing can be tolerated, a
point is finally reached where cutting quality
deteriorates and clogging begins to occur
because of too much buildup on the baffling and
housing.
4. Lower the deck to the normal operating position
and re-engage the deck lock levers.
Do not operate machine with deck tilt-up
pivot joint unlocked.

GHS Blower

Normally, the GHS blower operates with no mainte-
nance or cleaning. However, when mowing grass
that is dirty and damp (especially springtime mow-
ing), a deposit of dirt may accumulate inside the
blower housing, causing wear and binding of the
blower wheel. When operating in these conditions,
inspect the blower frequently for dirt buildup.
NOTE: A visual clue of binding of the blower wheel
is the blower blade tips are polished from rubbing
on dirt.
When a dirt deposit is found, use a high pressure
washer or water spray to clean the inside of the
housing as follows:
Before attempting to wash the blower,
stop the engine, remove the ignition key,
and disconnect the spark plug wires.
1. Remove the GHS blower drive belt tension by
depressing the idler pulley on the tightener arm.
Roll the belt off the blower pulley. The belt
should be clear of the blower pulley, allowing
free movement of the blower wheel.
66
CAUTION
DANGER
IMPORTANT: With the belt removed, the blow-
er wheel must spin freely. Any binding or drag-
ging of the wheel is an indication of dirt
buildup. This buildup must be cleaned to
avoid abrasive wear of the blower blades, ex-
cessive power loss and eventual loss of blower
performance (clogging).
2. Use a pressure washer or water spray, and di-
rect the spray inside the blower housing against
the blower blades. Water pressure will cause
the blower wheel to begin to spin and the com-
bination of spinning action and water will effec-
tively wash the inside of the housing. Spray may
be directed against the blower blades vertically
and horizontally to cause rotation in both direc-
tions for thorough washing action. Wash blow-
er until the blower wheel spins freely in both
directions.
3. Reinstall the GHS blower drive belt by reversing
the removal procedure.
Blower
Drive Pulley
Depress Idler Pulley
Down to Relax Belt
Collapse Blower Belt Tightener
to Remove GHS Blower Drive Belt

GHS Exhaust Screen

Refer to Cleaning the GHS Exhaust Screen in Op-
erating Instructions.
CLEANING
GHS Blower
Blower
Drive Belt
Pulley
Belt Tightener
Idler Pulley