Heating - Olsberg Pantoja 23/565 Instruction Manual

Adjusting the rotation angle
Tongue
Press down on the tongue to turn the Pantoja.
The Pantoja can be turned by 90° in 4 steps
Please note before heating for the first
time
•
Remove all accessories from the ash pan and
combustion chamber first.
•
The odour given off by the evaporation of the
protective coating disappears after the stove has
been burning for several hours (ventilate the
room well).
•
The stove has a high quality temperature re-
sistant coat, which does not achieve its final
strength until the stove has been heated for the
first time.
- You should therefore never leave anything on
the stove and not touch the surfaces as the paint
coat could otherwise be damaged.
Igniting
•
Empty the ash pan if necessary and slide back
in.
•
Open the primary and secondary air controller.
•
Place and ignite the kindling materials (paper,
ignition cubes,
•
Close the door to the combustion chamber so
that the kindling material can catch fire.
kindling wood, etc.).
•
As soon as the kindling material is burning well,
add a small quantity of fuel.
Using the air controller
Secondary air controller
The primary aire controller is located below the door
and the secondary air controller above the door.
•
Secondary air controller to the left ⇒ Open
•
Primary air controller pulled out
Primary air controller...
... OPEN Ignition adjustment max. heating output
... 1/3 OPENNominal heat output with billet wood
... 1/3 OPENNominal heat output with wood
briquettes
... CLOSED glow
As the secondary air also contributes to the cleanli-
ness of the glass pane, the secondary air controller
must always be moved in the direction of the open
position while the stove is lit.
As the performance of your stove is very much de-
pendent on the chimney draught, the primary air con-
troller has to be adjusted according to your own ex-
perience. Please note that you should not use your
stove if there is not an adequate air supply (slide
valve setting too low), as this causes the emissions
to increase.

Heating

•
Only place the quantity of fuel required to
achieve the heating requirement.
For a nominal heating output 5 kW:
- max. 2 kg billet wood
- max. 1,5 kg wood briquettes
- max 3 Brown coal briquette
•
Open the combustion chamber door slowly after
adding new fuel, as otherwise the combustion
gases can escape.
•
Empty the ash pan or combustion chamber in
good time. Otherwise it is possible for the com-
bustion air intake to be blocked or for the grate to
be damaged.
•
Only remove the ash pan to empty it. Always
keep the ash door firmly shut during heating.
•
Clean the ash pan compartment regularly after
removing the ash pan to remove any ash that
may have been spilled (e.g. use a vacuum
cleaner).
Primary air controller
⇒ Open
11