Page 2
HAND BOBBIN WINDER ssembly nstructIons DOUBLE-END WINDER SINGLE-END WINDER PARTS PARTS main assembly: clamp, base, main assembly: clamp, base, and and upright with drive center tip upright with drive axle (metal) (metal for regular and lace) drive wheel tail spindle with live center tip 3/8"...
Page 3
INSTALL THE DRIVE WHEEL INSTALL THE DRIVE SHAFT (ALL WINDERS) (SINGLE-END WINDER ONLY) Clamp the bobbin winder base to a Place the drive shaft on the drive axle at table top. Place three 3/8" washers on the the top of the upright. Line up the set screw drive wheel axle.
Page 4
Replacement drive bands can be purchased at your local weaving shop or on the Schacht website. Your hand bobbin winder has been carefully designed for years of trouble- free use. The bearings are all self-lubricating and under normal use should not require further lubrication.