Draining The Hot Water And Carbonation Tanks; To Drain Water From The Hot Tank; To Drain Sparkling Water From The Carbonation Tank - ReadyRefresh Allure Series User Manual

8. Fill the cold tank with clean bottled water
9. Plug the dispenser back into a power outlet, and drain the cold tank again completely.
10. Clean the no-spill adapter and baffle (previously removed) by washing both with warm
soapy water. Rinse thoroughly to remove any soap residue.
11. Replace the baffle by inserting it into the connections at the bottom of the cold tank.
Then replace the non-spill adaptor by pushing the assembly into the cold tank opening.

Draining the Hot Water and Carbonation Tanks

12. To drain water from the hot tank:

a) Remove the 3 or 5 gallon bottle from the dispenser, if installed.
b) Unplug the power cord, and rotate the dispenser to access the back surface
CAUTION: Water will be VERY hot! Wear protective gloves and use extreme caution.
c) Locate the hot drain port at the rear, and place a large bucket under the drain to catch
the hot water.
d) While pulling the knob on the hot tank drain plug outward, turn the drain plug
counter clockwise and pull out the plug.
e) After all hot water has drained into the bucket, close the hot tank drain by pushing in
the plug, and turning the plug clockwise until fully locked.

13. To drain sparkling water from the carbonation tank:

a) Remove the 3 or 5 gallon bottle from the dispenser, if installed, and unplug the
dispenser's power cord, if powered.
b) Locate the carbonation tank drain tube located at the rear of the dispenser
c) Remove the drain tube from the drain tube dock by pulling the tube downward
Rev. A - 060220