Installation - Controllers - Rheem Integrity 20 Owner's Manual And Installation Instructions

INSTALLATION - CONTROLLERS

CONTROLLERS
There are three types of Rheem controllers suitable for installation with this water
heater. They are the Kitchen controller (Rheem PN 299853), Bathroom1 controller
(Rheem PN 299854) and the Bathroom2 controller (Rheem PN 299855). They are
designed to be hard wired into the water heater using either the Kitchen controller
cable (Rheem PN 299856) or the Bathroom controller cable (Rheem PN 299857).
Notes:
Only one of each type of controller can be connected to the water heater.
Therefore, only a maximum of three controllers can be connected to each water
heater.
Extension cables are available from Rheem. Alternatively, the cables may be
extended using two-core flex with a minimum cross-sectional area of 0.5 mm
No other manufacturers' controllers are suitable for connection to this water heater.
Location
The controllers must be installed in dry, shaded and clean locations.
Do not install the controllers:
Near a heat source, such as a cook top, stove or oven. Heat, steam and smoke
will interfere with the electronic components of the controllers.
In direct sunlight.
In or near a wet area. The controllers are not waterproof. Water may damage the
controllers.
Outdoors. The controllers are not weatherproof.
KITCHEN CONTROLLER
COMPONENTS
BATHROOM1 AND 2
CONTROLLER COMPONENTS
Kitchen Controller
Bathroom Controller
Screw X 2
Screw X 2
Base Plate
Controller Screw
22
Base Plate
Controller Screw
.
2
Foam Packing