Advertisement
DSC-U50
2-2. MAIN CABINET ASSY
1 Make JIG as shown in a figure.
tape
16mm+
38mm
6 Put the tip of Jig into the position of a figure.
7 Push the battery holder and LCD section
until a 1mm crevice opens.
Jig
0 Push the LCD holder
for removing the boss.
qa Main cabinet assy
Note: Remove it while
taking care as
the flexible board
is connected.
2 Two screws
(lock ace)
3 Rotate the lens cabinet section.
5 Put the lens cabinet section
back in its place.
1mm
4 Two screws
(lock ace)
Boss
qs Flexible board (CN916)
8 Apply power in the direction of
arrow A by JIG, and remove boss.
9 Slide the main cabinet assy.
A
Boss
Jig
Apply power in the direction of
arrow A by JIG, and remove boss.
Slide the main cabinet assy.
Push the LCD holder for removing the boss.
2-4
Main cabinet assy
1mm
LCD window
A
Advertisement
