Related Manuals for HAI 32A00-1
Summary of Contents for HAI 32A00-1
- Page 1 Home Automation, Inc. Model 32A00-1 OmniTouch Touchscreen Installation Manual Document Number 32I00-1 Rev A August, 2003...
-
Page 2: Fcc Notice
FCC NOTICE This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Verified to comply with the limits of a Class B digital device pursuant to Part 15 of the FCC Rules. - Page 3 PLANNING It is very important to plan where the OmniTouch touchscreen will be installed and the gauge/type of wire you will use for the installation. In selecting a place to mount the touchscreen, be sure to avoid an area where studs, plumbing, or electrical wiring may be located behind the wallboard.
-
Page 4: Installation
INSTALLATION Hold the template (Installation Template – 32A10-1) against the wall so the top edge is at the appropriate height and parallel to the floor. Using a Punch, or similar instrument, punch through the center of each tick mark (+) on the template. Drill a 1/4"... - Page 5 Locate the retaining flange screws in the upper left and lower right corners. Turn the screws counterclockwise until the gap between the retaining flange and the housing flange is wider then the wall. WALL Place the assembled unit into cutout in the wall.
-
Page 6: Removing The Touchscreen
Turn the retaining flange screws clockwise until they are snug (do not over tighten). WALL Before installing faceplate, remove the protective film from the LCD area of the touchscreen. Fasten the faceplate onto the touchscreen by hanging the top of the faceplate on the top edge of the touchscreen, then gently snapping the bottom onto the touchscreen. - Page 7 CONNECTING TO OMNI II / OMNIPRO II Connect the "Yellow" and "Green" wires from the touchscreen to the "A" and "B" terminals under the section marked "CONSOLE" on the controller, respectively. Connect the "Red" and "Black" wires from the touchscreen to the "12V" and "GND" terminals under the section marked "AUXILIARY"...
- Page 8 CONNECTING TO OMNILT Connect the "Yellow" and "Green" wires from the touchscreen to the "YEL" and "GRN" terminals under the section marked "CONSOLE" on the controller, respectively. Connect the "Red" and "Black" wires from the touchscreen to the "12V" and "GND" terminals under the section marked "AUX"...
- Page 9 (other consoles or touchscreens already occupy the touchscreen address) or isn’t communicating with the controller, the following page is displayed. To assign an address to the OmniTouch touchscreen, press and hold the HAI logo for three seconds. The "Touchscreen Address" page is displayed.
- Page 10 (32R00-1) for additional information on these items. Note: In the event of an AC Power failure and the HAI controller is running on backup battery power, the touchscreen display will be lowered to its lowest viewable setting. Do not try to adjust the “brightness”...
-
Page 11: Specifications
SPECIFICATIONS Size: Backbox cutout: 5.375" W x 4" H Faceplate: 5.9" W x 4.6"H LCD View Area: 3.26” W x 2.47” H Operating Voltage: 9 – 15 VDC Maximum Current Consumption at 12 VDC: 300 mA based on Maximum Cable Length as defined in “Table 1”...
Need help?
Do you have a question about the 32A00-1 and is the answer not in the manual?
Questions and answers