System Operation; To Begin Play; To Change A V.disc Tm - VTech Home Edutainment System User Manual

SYSTEM OPERATION

TO BEGIN PLAY

• Make sure the unit is turned OFF.
• Press the
• Place the V.DISC™, label and printed side up, into the disc compartment
and onto the center hub.
• Close the Main Unit cover.
• Turn your TV on.
• Set your TV input mode to accept input from the port to which V.FLASH
is connected. In many cases this will involve setting the TV to " video"
mode; however, since all TVs vary, please refer to your TV or VCR
manual for further details.
• Make sure that both the Controller and AC adaptor are properly plugged
into the console and the wall outlet.
• Turn the V.FLASH
ON button. Enjoy your game!
• When not using your V.FLASH
EJECT button to remove the V.DISC™.
• Close the Main Unit cover.
NOTE:
• If you don't see the V.FLASH
the above. If there is still no picture on TV, press the RESTART button
and wait for a few seconds then press ON button again. Please refer to
Troubleshooting table for more information.
• Do not accidentally press the RESTART button while playing a game,
or the game will restart.
TO CHANGE A V.DISC™
• While the power is ON, press the
play.
• Press the
remove the V.DISC™ from the console.
• Place another V.DISC™, label and printed side up, into the disc
compartment and onto the center hub.
• Close the Main Unit cover.
• Press the
7
EJECT button to open the Main Unit cover.
TM
Home Edutainment System on by pressing the
TM
EJECT button to open the Main Unit cover and
ON button and start to play.
TM
, press the
logo screen on your TV, please review
OFF button to stop the game
OFF button and
TM