Table of Contents
Advertisement
Maintenance
Always switch OFF the power and disconnect the power plug of the
battery charger from the power outlet before starting maintenance.
Handheld Unit, Main Body, Battery Charger
• Wipe off any dirt from the product using a dry and soft rag.
• In case of stubborn dirt, clean using a soft damp rag soaked in a water solution
diluted with a little neutral detergent and then wipe with a dry rag.
• Do not use solvents like thinner, benzene, and spray type cleaners.
Dust Container (Nozzle)
• Remove any collected dust inside the dust container first and wash. Wipe with a
dry reg, leave it to dry well in a shade and attach it again to the main body of
handheld unit.
Filter, Filter Baffle Plate
• Do not wash the filter or the filter baffle plate in the washing machine.
• Do not dry them using a hot air blower such as a dryer or a hair dryer.
• In case of stubborn dirt or loss in suction power, wash as instructed below:
1. Remove the dust first.
2. Wash with water.
3. Leave to dry well in the
shade.
10
Floor Brush
Carry out the maintenance if any waste threads or hair gets tangled in the brush.
• Regular Maintenance
Slowly rotate the brush manually and remove any foreign
objects tangled around the brush.
Take out the wastes
Maintenance when the floor brush
cannot be manually rotated.
1. Unscrew the left hand side and
then lift and dislodge the brush
cover.
3. Take out the rotating brush and
remove the blockage.
Take out the wastes
2. Lift up the left side of the rotating
brush and then remove the belt
pulley from the belt.
Belt
4. Re-install the rotating brush again.
Finally, check if the brush cover
is securely fixed and the rotating
brush rotates properly.
11
Advertisement
Table of Contents
