EAW ADAPTive systems Accessory & Rigging Manual page 20

5. Lower the flown column until it just rests on top of the modules on the Caster Pallet, leaving
the Rigging Latches of the bottom module in the retracted position. The stacking keys will
assist alignment. (Fig. 2a)
6. On the bottom module in the flown Otto column, push over (to left) the Latch Grips. This will
deploy the captive Rigging Latches, which should drop into the Rigging Channel from their own
weight. If the Latches do not drop by themselves, there may be a misalignment between the
modules. If needed, press lightly until the Latch Grips are all the way down. If the Latches still
do not drop, retract and lock the Latch Grips, the raise and reseat the flown modules on the
stack and repeat Step 6. (If pressing the Latch Grips home requires significant force, it indicates
a problem that should be addressed.) Ensure that there is no orange visible on the latches
before moving to the next step. (Fig. 2b)
7.
Push the Pin Grips on the top Otto module on the Caster Pallet all the way in (Fig. 3), ensuring
that no orange marking is visible. (Fig. 4)
X4
19
Fig. 2a
Fig. 3
X4
Fig. 1b
X4
Fig. 2b