Canopy Light - piER plEASURE Hydraulic Boat Lift Owner's Manual

Canopy Light – 12 Volt System (DC) & 110 Volt System (AC)
Both hydraulic systems are equipped with a 12 volt canopy light. 110 volt system converts the
power to 12 volt for the light. The light plugs into the cord on the control pad (110 volt) or receiver
box (12 volt). Install the light cord through a hole in hydraulic box and slide the connections firmly
together. Using plastic cable ties, attach the light to the canopy frame in the desired location. The
light can be operated with both systems using the remotes. The 110 volt hydraulic can operate the
light using the control pad.
If the bulb needs to be replaced, replace it with a 12 volt DC bulb #912. Do not use a #921
bulb since this bulb is over 1 amp. Using the wrong bulb will result in damage to the
control board.
Page 14