Advertisement
1. Plug in the blender. The blender will emit a beep as the screen lights up.
2. Place the lid on the pitcher, insert the lid cap, and lock into place by rotating. This will remove
the E2 error message from displaying on the LCD panel.
3. Press the ON/OFF button, then select a program by pressing the Function button to cycle through
all preset programs. The recipe time information will be displayed on the LCD screen. For heating
programs, please do not ignore unspecified times. Preheating time may vary according to initial
temperature.
4. Press the ON/OFF button again to start the program.
If you selected a heating mode
1. The preheating animation will appear on the display during preheating.
2. Once the preheating phase is completed, the programmed cooking time will start to count down.
3. During heating, the blender will blend occasionally to avoid baffling and ensure even heating.
4. It is normal for the steam to come out of the top vent during the heating process.
Helpful tips:
Always operate the blender on a horizontal surface that is level, stable, and non-combustible.
Always operate the blender with the lid in place. E2 will be displayed on the LCD screen until
the glass pitcher is correctly installed onto the motor base with the lid locked into place.
Add the ingredients into the glass pitcher, not exceeding the maximum amount of 1200ml for
cold ingredients, 800ml for hot ingredients.
Speed:
1. When in standby mode, press the Speed button to adjust the blade speed.
2. Adjust the speed setting by using the + and - buttons. There are 10 total speeds. The default
setting is level 5.
3. After selecting a speed, press the ON/OFF button to confirm and start blending.
Using your blender
Controls Panel
05
Advertisement
