Astro Pneumatic Tool 30570 Manual

30570
Model:
WARNING
Study, understand and follow all instructions provided
with this product. Read these instructions carefully
before installing, operating, servicing or repairing this
tool. Keep these instructions in a safe accessible place.
INTENDED USE OF THE TOOL
The 30570 7" Cordless Polisher is designed to be used
by qualified professionals to detail, wax, polish and buff
painted panels using appropriate compounds and speeds
so as to not over-heat or damage the paint. Do not use
this tool outside of the designed intent. Never modify the
tool for any other purpose or use.
WARNING
Caution: To help prevent personal injury
• Normal use of this product is likely to expose the
user to dust and/or microscopic particles
containing chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm. Always wear appropriate
safety equipment and clothing when using this
product. Study, understand and follow all
instructions provided with this product. Failure to
read and follow all warnings and operating
instructions may result in damages and serious
injury or death.
• Always wear ANSI approved goggles when using
this product. (Users and By standers).
• Never use this tool for any application other than
for which it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
• Improper operation and/or maintenance of the
tool, modification of the tool, or use of the tool
with accessories not designed for it could result
in serious injury or death.
• Always select the correct accessories of the
correct size and design for the job that you are
attempting to perform.
• Always work in a clean, safe, well-lit, organized
and adequately equipped area.
• Do not begin repairs without assurance that
vehicle is in secure position, and will not move
during repair.
BEFORE USE
When unpacking, check the parts diagram and part
number listing on page 9 to make sure all parts are
included. If any parts are missing or damaged,
please call your distributor.
DO NOT DISCARD – GIVE TO USER
Product Type:
20V 7" BRUSHLESS VARIABLE SPEED
ROTARY POLISHER W/ 2 BATTERIES
1 YEAR LIMITED WARRANTY
• Astro Pneumatic Tool Co. warrants our products to the
original user against defective material or workman-
ship for a period of 1 year (except where noted on our
price schedule) from the date of 1st use. Astro
reserves the right to determine whether the product
failed because of defective material, workmanship or
other causes and to charge back for missing parts.
Astro Pneumatic Tool Co., at its discretion, will repair
products covered under this warranty free of charge.
The distributor should direct the original user to return
the product (with the exceptions listed below) with the
distributor's name, address, adequate proof of date of
purchase or a copy of warranty card, and a short note
explaining the problem. Failures caused by
accident, alteration, or misuse are not covered by
this warranty.
• Astro Pneumatic Tool Co. or its authorized service
representatives must perform all warranty repairs. Any
repair to the product by unauthorized service
representatives voids this warranty. The rights under
this warranty are limited to the original user and may
not be transferred to subsequent owners.
• This warranty is in lieu of all other warranties,
expressed or implied, including warranties of
merchantability and fitness for a particular purpose.
Some states do not allow the exclusion of limitations
of incidental or consequential damages so the above
limitations may not apply to you.
PLEASE DO NOT RETURN ANY PRODUCT WITHOUT CALLING
1-800-221-9705 FOR INSTRUCTIONS
PRODUCT INFORMATION
• Brushless 20V motor for efficiency and power with
6 adjustable soft-start speed settings from 400-2,200RPM
• Perfectly balanced at the hand and weighs 1lb less with
battery attached than industry leading 7" corded polishers
• Includes two batteries and quick charger for zero downtime
• Bale handle design for vertical or horizontal gripping
Specification:
Motor: Brushless DC-20V
Battery: 4.0Ah (X2)
Run Time: speed 6 (highest speed): around 45 min.
speed 1 (lowest speed): around 5 hours
No Load Speed: (soft start) 400, 760, 1,120,
Weight: 5.86lbs w/ battery, 4.1lbs tool only
Arbor Size: 5/8"-11
Pad Dia.: 180mm (7")
Switch Type: Slide Switch w/ lock
Charge Time: 80 min.
Page 1
www.astrotools.com
1,480, 1,840, 2,200 RPM