Lawn Solutions TA3016KAF1 Operator's Manual page 32

Engine loses power.
Engine overheats.
Machine pulls left or right (with levers
fully forward).
Machine does not drive.
Abnormal vibration.
Tines do not raise.
Tines do not engage the ground.
1. Engine load is excessive
2. Air cleaner is dirty.
3. Oil level in the crankcase is low.
4. Cooling fins and air passages for the
engine are plugged.
5. Vent hole in the fuel cap is plugged.
6. Dirt in fuel filter.
7. Dirt, water, or stale fuel is in the fuel
system.
1. Engine load is excessive
2. Oil level in the crankcase is low.
3. Cooling fins and air passages for the
engine are plugged.
1. Tire pressure in drive tires not correct.
2. Tracking needs adjustment.
1. Drive or pump belt is worn, loose or
broken.
2. Drive or pump belt is off a pulley.
1. Tine(s) is/are bent or unbalanced.
2. Tine mounting bolt is loose.
3. Engine mounting bolts are loose.
4. Loose engine pulley, idler pulley, or
blade pulley.
5. Engine pulley is damaged.
6. Belt is damaged.
1. Auxiliary pump belt problem.
2. Tine down pressure setting is too low.
3. Short in harness.
4. Auxiliary reservoir is low on oil.
1. Tine down pressure setting is too low.
2. Harness/switch is damaged.
3. Auxiliary reservoir is low on oil.
32
1. Reduce the ground speed or aeration
depth.
2. Clean or replace the air cleaner
element.
3. Add oil to the crankcase.
4. Remove the obstructions from the
cooling fins and air passages.
5. Clean or replace the fuel cap.
6. Replace the fuel filter.
7. Contact an Authorized Service Dealer.
1. Reduce the ground speed or aearation
path.
2. Add oil to the crankcase.
3. Remove the obstructions from the
cooling fins and air passages.
1. Adjust tire pressure in the drive tires.
2. See Motion Control Linkage
Adjustment in Adjustments section.
1. Change the belt.
2. Change the belt.
1. Install new tine(s).
2. Tighten the tine mounting bolt.
3. Tighten the engine mounting bolts.
4. Tighten the appropriate pulley.
5. Contact an Authorized Service Dealer.
6. Install new belt.
1. Tension or replace belt.
2. Increase down pressure.
3. Contact an Authorized Service Dealer.
4. Add oil to reservoir.
1. Increase tine down pressure.
2. Contact an Authorized Service Dealer.
3. Add oil to reservoir.