Download Print this page

Carlton SU 1000 Manual

Facial sauna

Advertisement

Quick Links

SU1000.qxd
12/09/2000
16:33
Page 1
safety first
Always place your facial sauna on a firm and level
surface.
Never immerse your facial sauna in water. Never
switch on your facial sauna without first filling the
reservoir with water. Switch off your facial sauna
when all the water has evaporated.
Never place your facial sauna on or near a
source of heat such as a cooker ring or gas flame.
Always keep the facial sauna out of the reach of
small children and never allow the mains lead to
hang over the edge of a work surface. Children
should be taught the dangers of boiling water and
should only ever use appliances while under close
supervision.
Do not interfere with the normal working of the
switch.
Disconnected from the mains when not in use.
Disconnect from power supply after use and
before cleaning.
Do not use if cable or plug is damaged.
Clean the appliance after use to avoid
accumulation of grease or other
residues.
Do not operate your facial sauna with a damaged
cord or plug or if the facial sauna is malfunctioning,
has been dropped or is damaged in any way.
specifications
Mains supply:
230-240V ~ 50Hz
Power consumption:
85W
Because we continually strive to improve our products we may change
specifications and designs without prior notice.
wiring instructions
Warning. This facial sauna must be earthed.
The wires in your facial sauna mains lead are coloured in accordance with the
following:-
The wire which is
Earth ( )
coloured Blue must be
connected to the terminal
in the plug which is
marked with the letter N
Neutral (N)
or coloured Black.
The wire which is
coloured Brown must be
Mains lead
connected to the
terminal in the plug
which is marked with the letter L or coloured Red.
The wire which is coloured Green and Yellow must be connected to the terminal in
the plug which is marked with the letter E or by the Earth symbol or coloured
Green or Green and Yellow.
You must use a 13 amp plug(BS 1363), and fit a 13 amp fuse(BS 1362). If any
other type of plug is used a 13 amp fuse must be fitted, either in the plug, adaptor
or at the distribution board.
If the power cord becomes damaged, it must be
replaced by your service agent or a qualified person
to prevent a hazard. Please contact the store where
you bought your facial sauna.
SU 1000
Live (L)
Fuse (3 AMP)
Wire clamp
facial
sauna

Advertisement

loading
Need help?

Need help?

Do you have a question about the SU 1000 and is the answer not in the manual?

Questions and answers

Summary of Contents for Carlton SU 1000

  • Page 1 Mains supply: 230-240V ~ 50Hz surface. Power consumption: SU 1000 Never immerse your facial sauna in water. Never switch on your facial sauna without first filling the reservoir with water. Switch off your facial sauna when all the water has evaporated.
  • Page 2 SU1000.qxd 12/09/2000 16:33 Page 2 using your facial sauna troubleshooting If the facial sauna doesn't work 2. Filling your facial sauna 1. Keeping the cord tidy please check that: Place your facial sauna on a level surface. Decide how long you want your sauna to last (20, 15, –...