Haztec Xpert SL Care And Maintenance

GLOBAL WARNING
Xpert SL Lightbar - Care and Maintenance
Please read these instructions before commencing installation or maintenance.

Installation

The instructions for mount kit assembly are packed in the kit supplied with the lightbar.
To ensure safe installation and use, this product should only be used in accordance with the instructions for this
lightbar and not be modified.

Cleaning

Xpert SL Lightbar lenses & external mouldings may be cleaned with either a soap & water mixture or a standard
glass cleaner.
DO NOT submerge the lightbar in water.
Ÿ
DO NOT use abrasive or solvent based cleaners as these will damage the surface of the lenses
Ÿ
and may also cause material damage to other polycabonate mouldings. Solvents containing
white spirit, fuels and acetone MUST BE AVOIDED.
DO NOT clean the metal extrusion of lightbar base with alloy cleaners as there is a risk of damage
Ÿ
to lenses & polycarbonate mouldings.
DO NOT use high powered jet washers. The underside of the lightbar is ventilated and the use of jet
Ÿ
washers may result in water penetration through these vent holes into the lightbar.
NOTE: If the lightbar is often exposed to environments containing salt water or large amounts of
Ÿ
dust, it is advised that the lightbar is cleaned as often as is necessary in accordance with the
instructions above to remove, & help prevent, the build up of salt/grime.
Removal of End & Centre Lenses.
To remove the lenses, first remove the two 'button head' end screws securing the end lens to the base using a
2.5mm hex bit driver. This will also release the end lens embellisher.
End lens
End lens
screws
Haztec International Ltd, Moorfield Estate Leeds LS19 7BN
T +44 (0)113 202 9115 F +44(0)113 2029158
E info@haztec.biz www.haztec.biz
Pass this leaflet to the end user.

Torque Values:

End lens screws: 2Nm
Bridge mould screws: 2.5Nm
End lens Embellisher
Page 1
PTO