Electrical Safety - DeWalt D27400 Original Instructions Manual

EN GLI SH
1 hex key 8 mm
1 Box spanner 10 mm
1 Box spanner 13 mm
1 Combination wrench
1 Box containing:
4 Legs
2 Short cross bars
2 Long cross bars
2 Motor frame brackets
1 Fence clamping rail
1 Fence driving rail
1 Bag containing:
2 Fence rail clamp knobs
5 M6 x 20 coach bolts
24 M6 x 16 coach bolts
3 M6 self-locking nuts
8 M6 cap nuts
32 M6 nuts
24 D6 Belleville washers
5 D6 compression springs
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. A)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
1 On/off switch
2 Table top
3 Table insert
4 Fence driving rail
5 Upper blade guard
6 Riving knife
7 Saw blade
8 Combined rip and mitre fence
9 Legstand
10 Floor anchor hole
11 Elevating handle
12 Fence clamping rail
6
INTENDED USE
Your D27400 site saw is a professional machine
designed for sawing wood and wood products at
construction sites.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This site saw is a professional power tool. DO
NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(Middle East and Africa)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see Technical Data). The minimum conductor
2
size is 1 mm ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always unplug the tool.