Additional Safety Rules For Table Saws - DeWalt D27400 Original Instructions Manual

EN GLI SH
6. Do not force the tool.
It will do the job better and safer at the rate to
which it was intended.
7. Use the right tool.
Do not force small tools to do the job of a heavy
duty tool. Do not use tools for purposes not
intended; for example do not use circular saws
to cut tree limbs or logs.
8. Dress properly.
Do not wear loose clothing or jewellery, as
these can be caught in moving parts. Non-
skid footwear is recommended when working
outdoors. Wear protective hair covering to
contain long hair.
9. Use protective equipment.
Always use safety glasses. Use a face or
dust mask if working operations create dust
or flying particles. If these particles might be
considerably hot, also wear a heat-resistant
apron. Wear ear protection at all times. Wear a
safety helmet at all times.
10. Connect dust extraction equipment.
If devices are provided for the connection
of dust extraction and collecting equipment,
ensure these are connected and properly used.
11. Do not abuse the cord.
Never yank the cord to disconnect it from
the socket. Keep the cord away from heat,
oil and sharp edges. Never carry the tool by its
cord.
12. Secure work.
Where possible use clamps or a vice to hold
the work. It is safer than using your hand and it
frees both hands to operate the tool.
13. Do not overreach.
Keep proper footing and balance at all times.
14. Maintain tools with care.
Keep cutting tools sharp and clean for better
and safer performance. Follow instructions for
lubricating and changing accessories. Inspect
tools periodically and if damaged have them
repaired by an authorized service facility. Keep
handles and switches dry, clean and free from
oil and grease.
15. Disconnect tools.
When not in use, before servicing and when
changing accessories such as blades, bits and
cutters, disconnect tools from the power supply.
4
16. Remove adjusting keys and wrenches.
Form the habit of checking to see that adjusting
keys and wrenches are removed from the tool
before operating the tool.
17. Avoid unintentional starting.
Do not carry the tool with a finger on the switch.
Be sure that the tool is in the "off" position
before plugging in.
18. Use outdoor extension leads.
Before use, inspect the extension cable and
replace if damaged. When the tool is used
outdoors, use only extension cords intended for
outdoor use and marked accordingly.
19. Stay alert.
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired or
under the influence of drugs or alcohol.
20. Check for damaged parts.
Before use, carefully check the tool and mains
cable to determine that it will operate properly
and perform its intended function. Check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting and any
other conditions that may affect its operation. A
guard or other part that is damaged should be
properly repaired or replaced by an authorized
service centre unless otherwise indicated in this
instruction manual. Have defective switches
replaced by an authorized service centre. Do
not use the tool if the switch does not turn it on
and off. Never attempt any repairs yourself.
WARNING! The use of any accessory
or attachment or performance of any
operation with this tool other than those
recommended in this instruction manual
may present a risk of personal injury.
21. Have your tool repaired by a qualified
person.
This electric tool complies relevant safety rules.
Repairs should only be carried out by qualified
persons using original spare parts; otherwise
this may result in considerable danger to the
user.
Additional Safety Rules for Table
Saws
1. Saw blades
Make sure that the blade rotates in the correct
direction. Keep the blade sharp. Do not use
blades of larger or smaller diameter than
recommended. For proper blade rating refer to
the technical data.