Foot Control Adjustment Procedure - Toro 260 Series Service Manual

HYDRO-GEAR TRANSAXLE

Foot Control Adjustment Procedure

If there is not enough ground speed in reverse and too
much in forward, adjustment can be made to correct
this.
1. Measure the distance between the footrest and
the back of the forward/reverse control pedal.
There should be 1¼" (31.75mm) to 1-3/8"
(34.925mm) gap (Figure 144).
1¼ - 1-3/8"
Figure 144
2. If adjustment is needed, unbolt the hydro control
rod where it connects to the hydro forward/reverse
pedal. The location is under the tractor on the
inside of the frame (Figure 145).
Figure 145
4 - 10
3. Loosen the jam nut and turn the rod end until you
achieve 1¼" (31.75mm) to 1-3/8" (34.925mm) gap
between the footrest and the back side of the
forward/reverse control pedal (Figure 146).
MVC-166X
MVC-167X
Figure 146
260 Series Tractor Service Manual
MVC-184X