Toro Recycler 20010 Operator's Manual page 22

3. Lift up on the side opening cover (Fig. 35).
4. Slide the chute over the opening with the slots in the
chute lined up with the tabs under the cover (Fig. 42).
2
m–4196
Figure 42
1. Side opening cover
2. Side discharge chute
5. Close the cover.
Removing the Side Discharge Chute
1. Stop the engine and disconnect the spark plug wire.
2. Open the side opening cover and remove the side
discharge chute (Fig. 42).
3. Close the cover.
4. Remove the knob, then install the side cover clamp
and the knob, securing the side opening cover
(Fig. 35 and 43).
Figure 43
1
3
4
3. Tab
4. Slot
m–4279
DANGER
POTENTIAL HAZARD
If the side opening cover is not securely
clamped in place, debris could be thrown out of
the side opening.
WHAT CAN HAPPEN
Thrown debris can cause serious personal
injury or death to the operator or bystanders.
HOW TO AVOID THE HAZARD
Always ensure that either the side opening
cover is closed and locked in place by the side
cover clamp or that the side discharge chute is
securely seated in place before starting the lawn
mower.
22