Accessories; Rear Grass Catcher - Toro Recycler 20010 Operator's Manual

1
Figure 34
1. Fuel tank cap
8. Check the engine oil level.
9. Connect the spark plug wire (Fig. 18).

Accessories

Accessories may have been shipped with your mower or
are available from your Authorized Toro Dealer. For
proper installation, follow these instructions.

Rear Grass Catcher

Install Discharge Tunnel
1. Stop the engine and disconnect the spark plug wire
(Fig. 18).
2. Remove the knob and side cover clamp (Fig. 35).
Figure 35
1. Knob
2. Side cover clamp
3. Remove and save the three bolts securing the
discharge cover to the mower (Fig. 36). Save the cover
and bolts for future use.
1626
1
2
3
m–4275
3. Side opening cover
2
1. Discharge cover
2. Bolt (3)
4. Remove the screw and nut from side of the mower
(Fig. 36). Save them for future use.
5. Install four grommets supplied with the grass catcher
into the four square holes in the mower (Fig. 37).
1
1. Grommet (4)
6. Insert the tongue of the discharge tunnel into the
mower (Fig. 38).
7. Align the holes in the tunnel with the grommets in the
mower (Fig. 38).
8. Ensure that the hole in the tongue aligns with the hole
in the side of the mower (Fig. 38).
19
3
1
Figure 36
3. Screw and nut
Figure 37
m–4275
2009