Table of Contents
Advertisement
1. Hitch plate
2. Route switch harness forward, along shift cable to
left side of machine. Harness must not interfere with
any hot (exhaust) or moving parts. Secure harness to
shift cable with cable ties.
6
Reinstall Hood
No Parts Required
Procedure
1. Reinstall hood to frame.
2. Reinstall ROPS shield shroud, seats, seat frame and
console cover plate, if applicable.
3. Reinstall overflow tube to radiator. Check coolant
level and replenish, if required.
7
Mount Lift onto Vehicle Frame
Parts needed for this procedure:
2
Reinforcing Plate
4
Flange HD. Capscrew, 3/8 x 1 inch
4
Flangenut, 3/8 inch
1. Remove any accessories mounted to top of frame in
forward position such as a 1/3 bed, power platform,
H.D. Hitch Frame extension tubes (Figure 8), etc.
G016821
Figure 7
2. Level switch bracket
1. Hitch frame extension tube
2. Locate and remove the threaded insert from the
mounting hole in left and right vehicle frame
channels, as shown in Figure 9.
1. Vehicle frame channel
Note: To prevent lift scissor arms from expanding,
pick up the platform lift from the bottom when
positioning on frame.
3. Position lift onto frame aligning mounting holes with
holes in frame (Figure 10).
10
Figure 8
Figure 9
2. Threaded insert
Advertisement
Table of Contents
