Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
1
Assembling the Trimmer
No Parts Required
Procedure
1. Slide the upper pole into the lower pole, lining up the groove
in the upper pole with the groove in the lower pole, and
tighten the screw so that the upper pole remains secure
during operation (Figure 1).
Note: The upper pole should bottom out in the lower pole.
Description
No parts required
Guard
Phillips head screw
Lock washer
Flat washer
Edge guard
Auxiliary handle
Latch
Brace
No parts required
Qty.
–
1
2
Mount the guard to the base of the
trimmer.
2
2
1
Install the edge guard.
1
1
Install the auxiliary handle.
1
–
Adjusting the handle height.
1. Upper pole
2. Screw
2. Cut the cable tie away from your body and remove it from
the trigger handle (Figure 2).
1. Cable tie
6
Use
Figure 1
3. Clamp
Figure 2
Advertisement
Table of Contents
