Toro Pro Sneak 360 Operator's Manual page 38

Problem
The engine overheats.
Excessive black smoke from exhaust.
Excessive white smoke from exhaust.
Possible Cause
1. More coolant is needed.
2. There is restricted air flow to the
radiator.
3. The crankcase oil level is incorrect.
4. The engine load is too excessive.
5. There is incorrect fuel is in the fuel
system.
6. The thermostat is damaged.
7. The fan belt is loose or broken.
8. The injection timing is incorrect.
9. the coolant pump is damaged.
1. The engine load is too excessive.
2. The air cleaner filters are dirty.
3. There is incorrect fuel is in the fuel
system.
4. The injection pump timing is incorrect.
5. The injection pump is damaged.
6. The injection nozzles are damaged.
1. The key was turned to the start position
before the glow plug light turned off.
2. The engine temperature is low.
3. The glow plugs are inoperative.
4. The injection pump timing is incorrect.
5. The injection nozzles are damaged.
6. The compression is low.
38
Corrective Action
1. Check and add coolant.
2. Inspect and clean the side panel
screens with every use.
3. Fill or drain the oil to the full mark.
4. Reduce the load; use lower ground
speed.
5. Drain and flush the fuel system; add
fresh fuel.
6. Contact your Authorized Service
Dealer.
7. Contact your Authorized Service
Dealer.
8. Contact your Authorized Service
Dealer.
9. Contact your Authorized Service
Dealer.
1. Reduce the load; use lower ground
speed.
2. Service the air filters.
3. Drain the fuel system and refill with
specified fuel.
4. Contact your Authorized Service
Dealer.
5. Contact your Authorized Service
Dealer.
6. Contact your Authorized Service
Dealer.
1. Turn the key to the run position and
allow the glow plug light to turn off
before starting the engine.
2. Check the thermostat.
3. Check the fuse, glow plugs and wiring.
4. Contact your Authorized Service
Dealer.
5. Contact your Authorized Service
Dealer.
6. Contact your Authorized Service
Dealer.