Advertisement
Batch loading of cards or fobs (Cont'd.)
e) The start memory location will now appear, default
being the first available number. A decimal point to left
will appear indicating that the initial memory location is
being selected. Select the desired "start" location by
scrolling up or down on the RED or BLUE buttons.
For a new system, the initial memory location is
typically 001. However, if 20 cards had previously been
enrolled in slots 001-020, your new "start" location
should be 021.
NOTE: If you accept 001 as the start location, you will
overwrite the existing cards/fobs.
f) Press the GREEN button to confirm the start memory
location.
g) Now select the final memory location by pressing the
RED button to scroll up until the desired location is
reached. A decimal point to the right will now appear
indicating that the final location is being selected.
h) Confirm selection of the final memory location by
pressing the GREEN button. The system is now ready
to "load".
i) Present the initial card in the sequence. The system
will now automatically "load" the sequenced cards
into the system.
Example: Start memory location = 120, final memory
location = 127. By presenting card #112233 to the
reader, 8 cards will be entered in memory slots #120-
127. The numbers enrolled will be 112233-112240
j) Press the GREEN button to confirm programming.
k) Press the RED & BLUE buttons to exit from the
Programming Mode.
Location
120
121
122
123
124
125
126
127
Card
112233
112234
112235
112236
112237
112238
112239
112240
2. Deleting Cards or Fobs
2.1 Deleting Individual Cards or Fobs
a) Press the RED and BLUE buttons simultaneously to
access the programming mode.
b) Select the storage location to be deleted by scrolling
up or down with the RED or BLUE buttons. If decimal
points are on, this indicates that the location has a
card/fob programmed into it.
c) Press the GREEN button. The letter -C- (cancel) will
now appear on the left-hand side of the display.
d) Press the GREEN button again to confirm deletion.
The decimal points will go off and the storage
location is now freed up, and the card/fob that was
programmed to that location will no longer work.
e) Repeat steps b-d to delete other codes.
f) Press the RED & BLUE buttons to exit from the
Programming Mode.
2.2 Deleting a set of Cards or Fobs
a) Press the RED and BLUE buttons simultaneously to
access the programming mode.
b) Press the YELLOW button to access the Function
selection menu.
c) Select Function F04 by pressing the red button 3
times.
d) Confirm your selection by pressing the GREEN
button.
e) Select the first location to be deleted by scrolling up
or down with the RED or BLUE buttons.
f) Press the GREEN button to confirm the first location
to be deleted.
g) Select the last location to be deleted by scrolling up
with the red button.
h) Press the GREEN button to confirm the last location
to be deleted. The letter C will appear on the left
hand side of the display.
i) Press the GREEN button again and the system will
automatically delete the range selected.
j) Press the RED & BLUE buttons to exit from the
Programming Mode.
2.3 Deleting all Cards or Fobs
a) Press the RED and BLUE buttons simultaneously to
access the programming mode.
Advertisement
