Plustek NVR X840P User Manual page 31

2. Select "General Camera" from the drop-down list. Enter the IP Camera's "Name"
that will be used throughout the menus and the user interface of the NVR Viewer,
the "Device Name", "IP Address", "RTSP Port", "RTSP Path (main stream)",
"RTSP Path (second stream)", "User Name" and "Password". Enter the password
again in "Confirm Password". Activate the "Enable default motion recording"
checkbox if desired.
3. Click the "Add" button to add the IP Camera to the channel list. The IP Camera's
connection, recording and alarm status will be shown.
Change the IP Camera information
1. In the channel list, you may select the IP Camera by clicking the respective
radio button.
2. You may click the "Edit" button to edit the information of the IP Camera.
3. You may click the "Delete" button to delete the IP Camera.
4. You may click the "Restore" button to reset the IP Camera to its factory default
values.
5. You may click the "Restart" button to restart the IP Camera.
6. You may click the "Motion" button to set the
event settings.
7. You may click the "Preset" button to set the drop-down list options of Preset
Positions in the live view window.
motion detection
27
window and the