Specifications
Power Output:
200 watts continuous, per channel into 8
ohms, any three main channels driven, from
20 to 20 kHz with no more than 0.5% THO.
Rear Center can deliver 100 watts minimum
into 8 ohms, with both rear channels driven,
time limited basis.
(Main channels are front left, front right,
front center, rear left, and rear right).
Power at clipping:
200 watts per main channel, all main chan-
nels driven into eight ohms.
300 watts per main channel, all main chan-
nels driven into four ohms.
(Time limited basis)
Frequency Response:
+1-
0.5 dB, 20-20 kHz, CD in stereo
Signal to noise ratio:
>95 dB, relative to full power, A-weighted,
COin
>87 dB, relative to full power, A-weighted,
Phono in
Input sensitivity:
CD: 300mV
Phono: 3mV
Tone control effect:
Bass:
+1-
9 dB
@
30 Hz
Treble:
+1-
8 dB
@
20 kHz
FM
Tuner:
Useable sensitivity (Mono)
1.6uV (75 ohms)
15.2 dBf(75 kHz Dev. 30 dB)
50 dB quieting sensitivity (Stereo):
31.6 uV (75 ohms)
41.2 dBf
Audio output frequency range:
30 Hz to 15 kHz. +0.5, -3 dB
AM Tuner:
Useable sensitivity (30% mod,
SIN
20 dB):
16 uV (600 uV
Imeter)
Signal to noise (30% mod., 1 mV input):
48 dB
Power requirements:
120 VAC model
120VAC 50-60 Hz, lOA
230 VAC model
230VAC 50-60 Hz, 5A
Dimensions:
Height: 6 1
I
16"
Width:
171/4"
Depth: 19"
(includes knobs and installed line cord)
Net weight:
38lbs
Sonic Holography is a trademark of Carver Corporation.
Manufactured under license from Dolby Laboratories.
"Dolby", "Pro Logic" and the double-D symbol are
trademarks of Dolby Laboratories. Confidential Unpub-
lished Works.
©1992-1997 Dolby Laboratories, Inc. All rights re-
served.
DTS is a trademark of DTS Technology.
All other trademarks are properties of their respective
owner's.
©2001 Carver Corporation.
All rights reserved. Carver Corporation reserves the
right to improve its products at any time. Therefore,
specifications are subject to change without notice.
Manual part number: 913-015-00 Rev B
€\
Specifications
W - - - - - - - - - - - O \ R V E R -
Need help?
Do you have a question about the C-1000A and is the answer not in the manual?