Advertisement
iNStaLLatiON
Fixing the anchor, Screw
cautiON
y Check the material of the wall and the thickness of the finishing.
y
y U se the anchors for wall material of concrete, light concrete, strong natural
y
stone, soft natural stone masonry
brick and hallow block that do not crack.
y
y
y When installing the product on wall material not designated, install the
y
product so that each fixated location can withstand the pull out load of 70
kgf (686 N) and shear load of 100 kgf (980 N) or above.
a. Use a drill bit Ø8 mm to drill a hole for the anchor location within a depth of
80 mm - 100 mm.
b. Clean the drilled hole.
c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the
angle adjusting part to face upward.
Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque
of 45 kgf/cm - 60 kgf/cm.
a
c
d
Anchor
Ring and Space steel fixing screw
b
5
iNStaLLatiON
Advertisement
