Kasco marine 2400EAF Owner's Manual page 10

1/4" x 1"
Bolt and
Locking
Nut
1/4" x 1-1/4"Bolt Power Cord
and Nut
.
STEP SEVEN
Insert the Spacer Bracket (Part B7)under the U-Brack-
et and inside the cage. Secure this assembly using one
1/4" x 1" Bolt (Part B9) and a 1/4" Lock Nut (Part
B11), and one 1/4" x 1-1/4" Bolt (Part B10) and a 1/4"
Hex Nut (Part B12). The longer bolt should be on the
side of the U-Bracket that is closer to the cord clamp.
Tighten the hardware using the 7/16" (11mm) wrench
and socket & wrench until the U-Bracket clamps
fi rmly around the cage (U-Bracket should pull together
slightly). Repeat with the second U-Bracket.
STEP EIGHT
Attach an Angle Bracket to each of the longer (1-1/4")
bolts on the U-Brackets (See photo for orientation)
with a 1/4" Lock Nut.
2400 & 3400
STEP NINE
Wrap the Draw Band (Part B5) around the motor
housing and position so that the back of the Draw
10
1/4" x 1"
Bolt and
Locking
Nut
1/4" x 1-1/4"Bolt
and Nut
4400 & 8400
Band touches the marks drawn in Step Five. There is
no front or back to the Draw Band itself - it is revers-
ible. Orient the arm of the Draw Band so it aligns
with the cord clamp on the cage of the motor housing
and is parallel to the Angle Brackets attached in Step
Eight. Secure using a 1/4" x 1" Stainless Steel Bolt
and a 1/4" Lock Nut. (See photo in next column)
STEP TEN
Attach the Angle Bracket on the motor to the Angle
Bracket on the Float using two 1/4" x 1/2" Bolts and
two 1/4" Lock Nuts (one set for each Bracket). See
photos for orientation based on model size. Also, the
cord clamp on the cage should be oriented toward the
Float.
Angle towards back
2400 & 3400
STEP ELEVEN
Attach the Draw Band on the motor to the Adjustment
Bracket on the Float using a 1/4" x 1/2" Bolt and a
1/4" Lock Nut. Select one of the fi ve possible posi-
tions to mount the Draw Band for your preferred
direction of fl ow. We do not recommend the two outer
(most upward and most downward) mounting posi-
tions for 8400 models.
Horizontal
Angled Up
STEP TWELVE
Attach the Ropes to the front (on the cage) and back
Angle Towards front
4400 & 8400
Angled Down