Advertisement
S
t
a
r
t
t
o
u
s
e
S
t
a
r
t
t
o
u
s
e
Install the memory card
Insert SD / MMC card saved with photos to the card slot of the photo frame.
•
Don't change the SD / MMC card while Picture Frame is powered on!
If you want to change the card turn the power off at first.
•
Please insert the card in a correct direction. Do not apply too strong a force when inserting
the card to prevent damaging the card or the component of digital photo frame. Please
check for a correct inserting direction if it can not be done.
•
Don't insert or pull out the saving card while reading information.
Connect the power supply
Insert one end of the power adapter to the AC power socket, and the other end to the DC socket at the
back of the photo frame.
Power on
The photo frame can be turned on automatically when the photo frame is connected to the power supply.
Power off
Disconnect the power supply; the digital photo frame will be turned off.
Description of function
It will begin to play photo automatically after power on.
After power on, hold
enter/ exit stand-by mode.
Press the
key to set the interval time of playing the photo. There are 10 options of 5s, 15s, 30s, 60s,
5 minute, 15 minute, 30 minute, 45 minute, 1hour and infinite.
(Note: The setting only controls interval to play pictures, excluding the time to reading pictures; and
some reading time may be extended for format or size of picture)
Press the
key to switch over the frame display type. There are 4 options of fill, original, auto fit, pan
scan.
Mode
fill
original
auto fit
pan scan
Press
to rotate the picture (rotate by 90 degrees each time).
for 5 seconds, power supply of display screen may be turned on/off to
Extend the frame to fill the whole screen
Zoom the frame to original size
Automatically fit the screen subject to the upper and lower boundary of the screen
Intercept picture automatically to display in full screen.
Description
4/5
Advertisement
