Miele HS15 Operating Instructions Manual page 40

en
Using the SRD hard floorbrush
(depending on model)
Please observe the flooring manu-
facturer's cleaning and care instruc-
tions.
This hard floorbrush is especially suit-
able for vacuuming floors with deep
gaps and crevices, e.g. old wooden
flooring.
Inserting batteries into the LED
handle (dia. 10 + 11)
(depending on model)
 Loosen the screws on the cover.
 Press down on both sides of the
cover to remove it.
 Take out the battery holder and in-
sert the three batteries supplied,
making sure the polarity is correct.
 Refit the battery holder. Arrows are
marked on the battery holder and
battery compartment as a fitting aid.
They should point in the same direc-
tion.
 Replace the cover and tighten the
screw back up again.
Activating the exhaust filter
TimeStrip change indicator on the
exhaust filter
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
12).
a AirClean
b AirClean Plus 50 (light blue)
c Silence AirClean 50 (grey)
40
d Active AirClean 50 (black)
e HEPA AirClean 50 (white)
If your vacuum cleaner is fitted with fil-
ter c, d or e, you need to activate the
exhaust filter timestrip.
 Press the release catch for the dust
compartment lid and raise the lid as
far as it will go (dia. 13).
 Remove the indicator strip (dia. 14).
 Press the exhaust filter TimeStrip
change indicator (dia. 15).
After approx. 10 - 15 seconds, a thin
red line will appear in the left hand side
of the display (dia. 16).
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
How the exhaust filter timestrip
works
The exhaust filter timestrip indicator
shows the remaining functional life of
the exhaust filter. After approx. 50 oper-
ating hours, or approx. one year of av-
erage use, the display will be com-
pletely filled with red (dia. 17).