Fd !000 Diskette Drive Assembly; Model 810 Printer (Optional) - Texas Instruments DS990/1 Site Preparation And Installation Manual

System model 1
Table of Contents

Advertisement

~ - - - - - - -
~
2262325-9701
CAUTION
The video module weighs approximately 9 kg
(20
lbs) and has a glass
CRT. Use care when lifting the video module from the shipping
container.
I.
Open the shipping container carefully.
2.
Unpack the shipping container and check that the video module does not have shipping
damage.
3. ·
Place the video module on a table using care not to damage the mounting feet and
interface connector on the bottom side of the video module.
3.4
FDlO00 DISKETTE DRIVE ASSEMBLY
Perform the following procedure to unpack, inventory and inspect the contents of the FD 1000
diskette drive assembly shipping container shown in figure 3-3.
WARNING
The FDlO00 diskette drive assembly weighs approximately 20.4 kg
(45 lbs). To avoid back injuries, two persons should lift the diskette
drive assembly from the shipping container.
I.
Open the shipping container carefully.
2.
Unpack the shipping container and check that the dual diskette drive assembly does not
have shipping damage.
3.5 MODEL 810 PRINTER (OPTIONAL)
Perfom the following procedure to unpack, inventory and inspect the contents of the Model 810
printer shipping container shown in figure 3-4.
WARNING
The Model 810 printer weighs approximately 25 kg (55 lbs). To avoid
back injuries, two persons should lift the printer from the shipping
container.
I.
Open the shipping container carefully.
2.
Unpack the shipping container and check that the printer does not have shipping damage.
Model 810 Printer Installation and Operation /ifanual, part number 939460-970 I, should
be included.
3.
Remove the four screws and flat washers from the bottom of the printer. These screws
hold the internal drive mechanisms in place during shipment.
4.
Open the access door, remove the styrofoam block covering the printhead, and manually
slide the printhead from stop to stop.
5.
Check that the printhead and the attached wire rope that pulls the printhead from side to
side moves freely, and that the wire rope is not unstrung.
6.
Close the access door.
22
Digital Systems Group

Advertisement

Table of Contents
loading

Table of Contents