Miscellaneous - Medisana MTD Instruction Manual

Repeatedly pressing the MEM button
measured previously. The unit will switch off if the oldest memory has been
reached.
In memory recall mode, the unit will switch off automatically after approx. 120
seconds if no button is pressed. Memory recall mode can be exited at any time
by pressing the START button
If all 60 memory locations in the memory are occupied, a new measured value
is saved whilst the oldest value is deleted.
If you are in memory recall mode, press and hold the MEM button
5.2
approximately 8 seconds. All measured data stored will be deleted automati-
Deleting memory
cally after three beeps. Only noughts will be shown on the display instead of
the measured values.

6 Miscellaneous

The battery change symbol
6.1
• The batteries are too low or empty. Replace all four batteries with new 1.5 V
Troubleshooting
Erratic measurements being displayed
• Cuff incorrectly fitted or not tight enough. Fit cuff correctly and tighten.
• You have changed position or the cuff has moved during the measurement.
• You have an irregular heartbeat. Even if your heartbeat is only slightly
• You have spoken during the measurement, you are nervous or you are
• You are not in the corrected seated or lying position. Please assume the
• The air hose is not connected or leaking. Check the connection between the
"EE" appears in the display
• The unit has not been inflated enough. Repeat the measurement
• A problem occurred during inflation or during the measurement. Repeat the
No display or display locked
• No batteries have been inserted, batteries wrongly inserted or batteries are
• A malfunction or fault has occurred. Briefly remove the batteries and then
Please contact the service centre if the error message appears again
when the measurement is repeated.
alkali AA batteries.
Keep still and do not move your arm or the cuff.
irregular, repeat the measurement. The unit is not suitable for people with
an extremely irregular heartbeat.
excited. Do not speak and breathe deeply two or three times in order to
relax.
correct position when taking the measurement.
upper arm cuff and the unit and check the air hose for leaks. Repeat the
measurement.
measurement.
completely empty. Insert batteries, check battery position or replace with
new batteries.
replace them.
5 Memory / 6 Miscellaneous
displays the respective values
, which will also switch the unit off.
appears in the display
GB
for
23