Advertisement
SR3
TSP065.doc
Issue 1.1 – June 2004
This document is the copyright of Money Controls Ltd and may not be reproduced in part or in total by any means,
electronic or otherwise, without the written permission of Money Controls Ltd. Money Controls Ltd does not accept
liability for any errors or omissions contained within this document. Money Controls Ltd shall not incur any
penalties arising out of the adherence to, interpretation of, or reliance on, this standard. Money Controls Ltd will
provide full support for this product when used as described within this document. Use in applications not covered
or outside the scope of this document may not be supported. Money Controls Ltd. reserves the right to amend,
improve or change the product referred to within this document or the document itself at any time.
©Money Controls 2004. All rights reserved.
Advertisement
Table of Contents
Related Manuals for Money Controls SR3
Summary of Contents for Money Controls SR3
- Page 1 Issue 1.1 – June 2004 This document is the copyright of Money Controls Ltd and may not be reproduced in part or in total by any means, electronic or otherwise, without the written permission of Money Controls Ltd. Money Controls Ltd does not accept liability for any errors or omissions contained within this document.
- Page 2 Overview of test box ............................. 5 Test Box Functions ..........................5 3.1.1 ACCEPT LINES..........................5 3.1.2 INHIBIT / ENABLE SWITCHES ....................... 6 3.1.3 REJECT LED........................... 6 Tables Table 1: SR3 Mode 1 Credits ..........................5 ©Money Controls 2004. All rights reserved. Page 2 of 7...
- Page 3 TSP065.doc Issue 1.1 – June 2004 Diary of Changes Issue 1.0…………………………………………………………………….….…………29 April 03 Issue 1.1…………………………………………………………………….….………….30 June 04 Changed footer ©Money Controls 2004. All rights reserved. Page 3 of 7...
- Page 4 Issue 1.1 – June 2004 Introduction The test box has been designed to allow the testing of selected parallel functions of any SR3 acceptor. In order to function, the test box must be supplied with 12V - 24V DC. ©Money Controls 2004. All rights reserved.
- Page 5 Coin 11 Coin 12 NB – The SR3 cannot have the parallel and the serial credit codes programmed onto its EEPROM at the same time. An alarm signal is displayed by all accept lines being activated at the same time (All LED’s illuminated)
- Page 6 As the name suggests these allow the user to enable or disable the coins on the acceptor through the parallel interface. 3.1.3 REJECT LED The LED illuminates whenever a reject is detected (Pin 5). ©Money Controls 2004. All rights reserved. Page 6 of 7...
- Page 7 This manual is intended only to assist the reader in the use of this product and therefore Money Controls shall not be liable for any loss or damage whatsoever arising form the use of any information or particulars in, or any incorrect use of the product.
Need help?
Do you have a question about the SR3 and is the answer not in the manual?
Questions and answers
our money-change display shows us an error when we install/put the cable the money cotrol device.The led stas red even when we do the right way. it says "uncontroll coin".what can we do or what do we do in the wrong way?