Preventative Maintenance / Cleaning; Troubleshooting; Indicator Lights On Top Of Bottle - O3 Waterworks SB-100HD User Manual

Sanitize Hard Non-Porous Surface
Hold the spray bottle 6 to 8 inches from the surface and spray evenly until
wet. For 99.9% e ectiveness against common pathogens allow to stand
for 30 seconds. Wipe with a clean cotton or microfiber cloth or allow to
air dry. No rinsing is necessary (leaves no residue). Ozone is generated on
demand. While spraying, the blue indicator will light when the unit is
operating properly.
PR EVENT AT IV E M AI NT ENAN CE & C LE A N I N G
1.
2.
3.
TRO UBLESH OOT I N G
5.1
Charge unit nightly to ensure full capacity the next day.
Clean bottle with moistened cloth only.
Do not use chemicals or cleaners.
When bottle is not in use for an extended period of time, open
the fill cap and empty the reservoir by tilting the bottle and
allow water to drain out the fill port. Leave fill cap unplugged.
Do not spray the bottle with an empty reservoir.

INDICATOR LIGHTS ON TOP OF BOTTLE

LIGHTED INDICATORS
SOLID BLUE
ONE RED FLASH
TWO RED FLASHES
THREE RED FLASHES
TWO RED & BLUE FLASHES
ALL OTHER PROBLEMS
SYSTEM MESSAGE
System is operating properly
Battery is low
Charger is connected, remover charger
Battery needs recharging
System fault; recharge and try again.
If error persists, follow the Prime the Spray
Bottle section on page 8. If error persists,
contact service department.
Contact service department.
9