O3 Waterworks SB-100HD User Manual page 8

8
Fill the Reservoir
Prepare 10 oz of clean, cold potable water to
fill the bottle. Remove the fill plug and tilt the
bottle at a 45° angle. Fill the reservoir with
10 oz of clean, cold potable water. Replace
the fill plug securely. Return bottle to vertical
position and check fill line. Adjust until water
reaches fill line. Do not overfill. Do not fill with
hot water or any cleaning products.
CAUTION
FILL WITH CLEAN, COLD POTABLE WATER ONLY.
DO NOT OVERFILL THE BOTTLE. DO NOT RUN
WATER INTO THE CHARGER PORT. WATER
TEMPERATURE 40°F to 86°F (4°C to 30°C)
Prime the Spray Bottle
When new, or after long storage, the ozone
generator in the head of the bottle may
become de-primed. When the ozone cell is
dry, the blue light will not illuminate while
spraying. A primed spray bottle should
spray uninterrupted for at least 30 seconds
with the blue light illuminated.
To prime the spray bottle, continue to
spray with the blue light o
light turns on. If the blue light does not
illuminate after 2 minutes of spraying, the
bottle may need to be primed using salt.
Additionally, if the bottle starts spraying
with the blue light illuminated and then
stops spraying with the blue and red lights
then flashing twice, your bottle may need
to be primed using salt.
To prime the spray bottle with salt:
1. Fill the spray bottle with water
2. Add 1 tsp of regular table salt
3. Spray the full tank into the sink
4. Fill the spray bottle with fresh tap water
5. Your bottle is now ready to use
Please note: the ozone cell may need to be
re-primed with 1 tsp of salt if unit is unused
for 3 or more months.
If additional support is needed, contact:
support@o3waterworks.com
until the blue
Remove cap.
Fill with 10 oz of only water.
Secure fill plug.
Sit bottle on counter and check
water level with fill line.
Hold 6-8" away from surface.
While spraying, blue light indicates
unit is working properly.