Setting Up - Haier BD-88DEM Manual

Setting up

Remove all package parts, the foam base and the adhesive tape fixing

accessories.
Place the freezer in a proper location.

Clean the inside and outside of the freezer before use.

After the appliance has been levelled and cleaned, let it remain idle for at

least 6 hours before switching it on so as to ensure its normal running.
Placing Environment
The freezer should be placed on a flat and solid ground. If the appliance is
placed on a pedestal, flat strong and fire-resistant materials must be used.
Never use the foam packing material as a pedestal.
Never place the freezer in a damp area or location where it may be
splashed with water. Clean and dry any water splashes and stains with soft
cloth in time to prevent rust.
Do not place the freezer where the environment temperature is too low
(under 5℃), do not keep the freezer outdoors or in the rain.
Do not place the freezer under the sunlight directly and keep it away from
heat to ensure the performance of the freezer.
Install the appliance in a well ventilated place and a space at least 10cm
must be kept above and around the freezer.
Feet-adjusting
If the freezer is slightly unstable, you can prolong or shorten the
adjustable feet of the freezer by turning them clockwise or counter
clockwise.
Connecting to the mains
Powere supply(AC) and voltage at the operating point must comply with the
details on the rating plate. Which is located on the freezer compartment.
Connect the appliance with a properly earthed fused plug and socket

6