Advertisement
Quick Links
Advertisement
Related Manuals for Bakker Elkhuizen WORK & MOVE Desk
Summary of Contents for Bakker Elkhuizen WORK & MOVE Desk
- Page 1 WORK & MOVE Desk Installation guide www.bakkerelkhuizen.com Work Smart - Feel Good...
- Page 2 Parts: A. Cantilever (2x) H. Power cable - 3x Cable clamps B. Columns (2x) I. Tabletop - 8x M6 screws for C. Beam K. Caps with screws mounting the D. Feet (2x) for the columns feet on columns. E. Wireless Bluetooth J.
- Page 3 Turn tabletop upside down with the drill holes facing up. Extend beam to required length (width 1150 to 1750 mm), adjustable in 50 mm steps. Make sure, when placing the beam on the tabletop, that the RJ45 socket is on the same side as the drill holes for the desk controller. The beam must be pulled completely apart to make sure the drive shaft is not pulled apart.
- Page 4 Place a cantilever slightly tilted at end of beam. Press cantilever into place until a click is heard and pawls lock cantilever in correct position. Mount cantilever on the end of both sides of the beam. Make sure that the cantilevers are placed correctly and cannot be twisted off the beam.
- Page 5 Fasten frame to tabletop using 20 mounting screws as follows (lining up with drill holes): 8 screws at ends of beam. Use one of these to fix mains cable to beam with cable clamp creating a cable relief, see step 9. 4 screws at extension points.
- Page 6 Mount columns. Ensure columns are completely retracted. If the column extracts when turned upside down, press by hand to completely retracted position. Tilt columns and place correctly on beam using guiding notches. Fix column to beam by pressing down until a “click” both is heard and pawls lock column in correct position.
- Page 7 Mount manual controller or the WORK & MOVE cable. Ensure that only one manual controller is connected to the beam Inside the at the same time.* RJ45 socket * If this is connected you can put the orange WORK & MOVE cable into the RJ45 socket so you can operate the table with the WORK &...
- Page 8 Mount feet. 10.1 Mount feet on columns using eight M6 mounting screws. Work Smart - Feel Good...
- Page 9 10.2 Mount adjustment screws. Turn the WORK and MOVe desk around on his feet and make sure that it’s level. If necessary, level out the table with the adjustment screws (see 10.2). Connect the WORK & MOVE desk to the power outlet and check that both the manual and WORK &...
- Page 10 Notes: Work Smart - Feel Good...