woundwo WINGLINE Mounting Instructions

Hide thumbs Also See for WINGLINE:

Advertisement

Quick Links

930113 _FR
Wingline
MOUNTING INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WINGLINE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for woundwo WINGLINE

  • Page 1 930113 _FR Wingline MOUNTING INSTRUCTIONS...
  • Page 2: Table Of Contents

    This symbol highlights important product information for the installation engineer. 1.2 general safety information The WO&WO Wingline awning has been designed and manufactured in conformity with DIN EN 13561. However, when the awning is mounted or operated, the persons involved in the respective activity may be put at risk if the relevant instructions are not observed.
  • Page 3: General Safety Information

    20 - 27 km/h Class 2 Fresh wind 5 (according to Beaufort wind scale) 29 - 38 km/h Class 3 Strong wind 6 (according to Beaufort wind scale) 39 - 49 km/h Classification of the WINGlINE awning: Version / 1500 mm 2000 mm 2500 mm 3000 mm 3500 mm 4000 mm 4500 mm...
  • Page 4: Mounting Situations: Floor, Floor/ Wall

    WINGLINE MOUNTING INSTRUCTIONS 2.4. mounting situations System width System width         Lower edge  of wall bracket  Mounting with 2 posts Mounting with 1 post and wallbracket      ...
  • Page 5: Mounting Posts/Bracket

    WINGLINE MOUNTING INSTRUCTIONS 2.5. mounting posts/braCket setting posts Wingline projection 1500mm 2000mm 2500mm 3000mm 3500mm 4000mm 4500mm setting post system width 1950 300 - 750mm 2100 350 - 750mm 2450 150mm 300 - 750mm 2600 ↓ 350 - 750mm 2700 150 - 200mm ↓...
  • Page 6 WINGLINE MOUNTING INSTRUCTIONS For structural reasons, the feet of the posts must be aligned so that the gusset plates point in the extended directions of the awning!  Set up feet (see Item 2.4. Mounting situations)  vertically   The base must consist of a strong concrete slab or at least an  80x80x100cm (LxWxD) concrete foundation! ...
  • Page 7: Assembling The Awning

    WINGLINE MOUNTING INSTRUCTIONS 2.6. assembling the aWning Ensure that sufficient personnel or suitable mounting aids are available to lift the awning. The weight of the cross member assembly with arms can be up to 120kg; the weights are specified on the packaging.
  • Page 8: Assembly With 1 Post And Wall Connection

    WINGLINE MOUNTING INSTRUCTIONS 2.6.2 assembly With 1 post and Wall ConneCtion • Push the machined side part at the cross tube  end with bore onto the cross tube until it is fully in. • Secure side part with threaded pins and counternuts. • Depending on the drive side, mount either the counter bearing or the motor flange.
  • Page 9: Initial Operation

    WINGLINE MOUNTING INSTRUCTIONS initial operation Before the initial operation of the awning, remove all objects (e.g. ladders, tools etc.) from the full travel range (in/out) of the awning and from underneath the awning. During the trial operation, ensure that nobody is in this area – there is a risk of injury in case of a malfunction. For trial operation, always use the test cable (no automatic control units etc.). In addition, the operator must be able to see the awning. The end position switches of the motors are factory set. However, readjustments on location pursuant to Item 3.2.
  • Page 10: Adjusting End Positions/Finishing The Mounting Of The Drop Bar Holder

    WINGLINE MOUNTING INSTRUCTIONS Post 2600 mm Post 3000 mm Post 3400 mm projection 3.2. adjusting end positions/finishing the mounting of the drop bar holder The end positions of the awning are preset in the factory.  If the inclination is changed, a correction may be necessary.
  • Page 11: Mounting The Roof

    WINGLINE MOUNTING INSTRUCTIONS  3.3. mounting the roof • The awning is in the back end position.  • Place the premounted roof from above onto the links of the side parts. • Screw the roof to the side parts.  In the version with 2 posts, use 4 screws each on the fronts of the side parts. In the version with 1 post and wall connection on the ...
  • Page 12 WWW.WoundWo.COM WO&WO Sonnenlichtdesign GmbH & Co KG Hafnerstraße 193, 8054 Graz, AUSTRIA office@woundwo.at Austria Germany Tel +43 (0)316 2807 - 0 Tel +49 (0)5684 9232 - 0 Fax +43 (0)316 2807 - 8100...

Table of Contents