Summary of Contents for STODDART Power Soak PS-200
Page 1
User Manual PS - 200 A guide on the use, care and maintenance of your quality Power Soak product Revision: B - 18/08/2020...
Page 2
Page Intentionally Left Blank Due to continuous product research and development, the information contained herein is subject to change without notice. www.stoddart.com.au www.stoddart.co.nz Page 1...
Page 4
“right to left” or “right hand” unit will start with the scrap area and/or wash tank on the right hand side� At Stoddart, we take pride in manufacturing the Power Soak line and are committed to standing behind our customers and products 100%�...
The manufacturer declines any liability for damages to persons and/or things due to an improper/wrong and/or unreasonable use of the machine • Only specifi cally trained/qualifi ed Technicians (Stoddart, one of our service agents, or a similarly qualifi ed persons) should carry out any and all repairs, maintenance and services Due to continuous product research and development, the information contained herein is subject to change without notice.
Spray Rinse Sanitiser Tank Rinse Tank Wash Tank Automatic Chemical Dispenser PS 200 Control Unit Drain Release Drain Release Due to continuous product research and development, the information contained herein is subject to change without notice. www.stoddart.com.au www.stoddart.co.nz Page 5...
There is a potential of drowning for any person whose head becomes submerged in the fl uid contained in the sinks along with other hazards identifi ed in this manual� Due to continuous product research and development, the information contained herein is subject to change without notice. www.stoddart.com.au www.stoddart.co.nz Page 6...
U.S Patent Number 4773436 - other foreign patents apply in Australia Europe and Japan Power Soak is a registered trademark of Cantrell Ind., Inc. Licensed by Cantrell Ind., Inc. Due to continuous product research and development, the information contained herein is subject to change without notice. www.stoddart.com.au www.stoddart.co.nz Page 7...
Page 9
Solid Illumination - “CHANGE SANITISER SOLUTION” - After two (2) hours, the sanitiser TANQUE PARA tank must be drained and refi lled� SANEAMIENTO Due to continuous product research and development, the information contained herein is subject to change without notice. www.stoddart.com.au www.stoddart.co.nz Page 8...
Sanitisers Kay Quat II Sanitiser is the recommended chemical and is available from Stoddart� (Order form on Page 17)� The method of sanitising used in your Power Soak system is a “chemical sanitising” method� There are a number of products on the market that work well�...
Page 11
Furthermore, standard detergent is a high alkaline product which is not mild on hands and skin, unlike the recommended product� Stoddart has recommended chemicals and accesories available in stock for orders. please use the order form on Page 17.
Page 12
Most chemical companies recommend changing wash water after a certain time frame� Those times vary, but are generally around four hours� Check with Stoddart service department on how often to replace your sanitiser� 5.2 Automatic Chemical Dispenser Priming When Sanitiser and Detergent bladers are replaced, locate the “prime”...
Page 13
There are no moving parts within the wash sink that could cause bodily harm, however moving pots and pans may cause harm� Due to continuous product research and development, the information contained herein is subject to change without notice. www.stoddart.com.au www.stoddart.co.nz Page 12...
Page 14
Start with a fresh washing solution� Load the items to be deep cleaned into the Power Soak’s wash tank� Press the green START button to start the wash action� Leave it to run overnight� A different chemical may be beneficial for this cycle, contact the Stoddart Service Department�...
There are no other preventive maintenance procedures that you will need to perform on your Power Soak system� You need not be concerned about greasing the motor bearings, as they are permanently sealed� If you have any questions regarding the preventive maintenance procedures, please contact the Stoddart Service Department 24/7 at 1300 307 289. Due to continuous product research and development, the information contained herein is subject to change without notice.
(the white plastic disc with a metal centre)� If the above trouble shooting procedures do not correct the problem, you must contact the Stoddart Soak Service Department 24/7 at 1300 307 289.
Page 17
8.6 Pump Works - Heater Does Not Work Look For Correction Water temperature < 43°C Contact Stoddart Service Department Water temperature between 43°C and 48°C Normal operating temperature Water temperature > 48°C Water too hot – reduce temperature to 46°C with ice or cold water Due to continuous product research and development, the information contained herein is subject to change without notice.
Page 18
Operation 9.0 Chemical Order Form CHEMICAL ORDER FORM Scan/Copy - Complete - Email to: spares@stoddart.com.au or Contact 1300 307 289 Name of Business Name of Contact Street Address Suburb State Postcode Phone Email QTY. Code Description Required Kay “Quat II” Sanitizer CNCL.0090...
Page 19
Due to continuous product research and development, the information contained herein is subject to change without notice. www.stoddart.com.au www.stoddart.co.nz Page 18...
Page 20
Australia Service / Spare Parts Sales Tel: 1300 307 289 Tel: 1300 79 1954 Email: service@stoddart.com.au Email: sales@stoddart.com.au Email: spares@stoddart.com.au www.stoddart.com.au Australian Business Number: 16009690251 New Zealand Service / Spare Parts Sales Tel: 0800 935 714 Tel: 0800 79 1954 Email: service@stoddart.co.nz...
Need help?
Do you have a question about the Power Soak PS-200 and is the answer not in the manual?
Questions and answers