Advertisement
Quick Links
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
Protecta – (LED) Luminaires (Industrial).
Important:
I-PR3I-01.doc
Please read these instructions carefully before installing or maintaining this equipment.
Good electrical practices should be followed at all times and this data should be used
as a guide only.
MODEL SIZE
02L
04L
07L
Issue 03
DIMENSION 'A'
DIMENSION 'B'
742
742
1352
18/07/2019
IOM – PROTECTA - LED (IND)
400
400
700
1
Advertisement
Related Manuals for Chalmit Protecta Series
Summary of Contents for Chalmit Protecta Series
- Page 1 IOM – PROTECTA - LED (IND) INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS Protecta – (LED) Luminaires (Industrial). Please read these instructions carefully before installing or maintaining this equipment. Important: Good electrical practices should be followed at all times and this data should be used as a guide only.
-
Page 2: Specification
IOM – PROTECTA LED (IND) Specification Type Of Protection Standards EN 60598-1, EN 60598-2-22 Area Classification Industrial, (Non- Hazardous) -25°C to +45°C Ambient Ingress Protection IP66/67 to EN 60529 CE Mark The CE marking of this product applies to "The Electrical Equipment (Safety) Regulations 2006", "The Electromagnetic Compatibility Regulations 2004", the “Waste Electrical and Electronic Equipment Regulations 2006”. -
Page 3: Light Emitting Diodes (Led)
IOM – PROTECTA LED (IND) Warning: Luminaires are assessed and/or tested for EMC requirements. This is based on the disposition of entry cables and, where appropriate, through wiring arrangements as supplied or specified. Users must take care not to introduce wiring into parts of the apparatus materially different to that which could be reasonably inferred from the disposition of fixed supply terminals and specified wiring. - Page 4 IOM – PROTECTA LED (IND) the clamping bar will begin to open. Insert the tool in the other clamping bar slot and gently lever away from the diffuser the clamping bar will open and the cover will be retained by the hinge. Should difficulty be experienced reinsert the tool in the first slot and repeat the procedure.
- Page 5 IOM – PROTECTA LED (IND) 3.9 Inspection and Maintenance On battery models, we recommend that the battery duration is checked periodically. Important: Isolate the mains supply and disconnect the battery terminal before carrying out any work. 3.9.1 Replacement of Electronic Ballast and EM convertor Unit (Where Fitted) The electronic ballast and EM convertor contain no replaceable parts.
- Page 6 IOM – PROTECTA LED (IND) To comply with the Waste Electrical and Electronic Equipment directive 2012/19/EU the apparatus cannot be classified as commercial waste and as such must be disposed of or recycled in such a manner as to reduce the environmental impact. Table A Series Standard circuit Refer to Section...
- Page 7 IOM – PROTECTA LED (IND) LED Indicator - A bi-colour LED indicates the status of the module as follows: LED Indication Status Comment Permanent green System OK AC mode Fast flashing green Function test underway (0,1 sec on – 0,1 sec off) Slow flashing green Duration test underway (1 sec on –...
- Page 8 2011/65/EU RoHS II Directive On behalf of the Chalmit, I declare that, on the date the equipment accompanied by this declaration is placed on the market, the equipment conforms to all technical and regulatory requirements of the above listed directives.