Troubleshooting - West Marine PowerStation Pro 15808520 Owner's Manual

TRoUBlESHooTinG

unit will not charge
• Make sure the inverter power switch is in the off position.
• Make sure a suitable gauge extension cord is properly connected to both the unit and a functioning
AC outlet, or
• Make sure the 12 Volt DC charging adapter is properly connected to both the unit and a functioning
DC power source.
unit Fails to jump start
• Make sure a proper polarity cable connection has been established.
• Make sure unit' s jump starter power switch is in the on position.
• Check that unit has a full charge. Recharge unit if necessary.
120 Volt ac outlet will not power appliance
• Make sure the inverter power switch is in the on position.
• Make sure the appliance being powered does not exceed 500W.
• Make sure you have followed all the steps in the 120 AC portable power supply instructions carefully.
• Refer to the important notes included in that section that explain common problems and solutions.
• Check that unit has a full charge. Recharge unit if necessary.
12 volt Dc portable power supply will not power appliance
• Make sure the appliance does not draw more than 5 amps.
• Check that Jumpstarter has a full charge. Recharge unit if necessary.
usB power port will not power appliance
• Make sure the USB power button is in the on position.
• Some USB-powered household electronics will not operate with this USB charging/power port.
Check the manual of the corresponding electronic device to confirm that it can be used with this
type of USB charging/power port.
• Check that unit has a full charge. Recharge unit if necessary.
leD area light does not come on
• Make sure the area light on/off button is in the on position
• Check that unit has a full charge. Recharge unit if necessary.
portable compressor will not inflate
• Make sure the compressor power switch is in the on position.
• Check that unit has a full charge. Recharge unit if necessary.
• Make sure the nozzle connector is securely screwed on to the valve stem when attempting to inflate
tires; or that the nozzle adapter is securely screwed into the SureFit™ nozzle connector and is
inserted properly into the item to be inflated on all other inflatables.
• The compressor may be overheated. Press the compressor power switch to turn the compressor off.
Restart after a cooling down period of approximately 30 minutes.
POWERSTATION PRO WEST MARINE
17